The ALDL Kit includes: Brand new ALDL Cable; Choice of one of our softwares (Default is Advanced Engine Diagnostics) Printed quick startup guide and installation USB; Most of all, professional customer service to help out with any questions! Diagnostic Software. Driver software for all of our USB products: VCP Drivers. ALDL OBD1 software for our ALDL cables.

Trafaret objemnij bukv russkogo alfavita krasivie. Usb ferrite bead.png (68.05 KiB) Viewed 16642 times In the kit 1x USB ALDL Cable 1x 1.5m Shielded USB cable with ferrite bead. Beware the clones PCMHACKING.net products use only genuine components. Our ECM Comms boards use a genuine FTDI chip which works fine with the latest drivers.

Clone FTDI chips are in circulation. See here for more information More information If you need more information about the use of this hardware, click the FAQ button at the top/right of the forums and have a read of the documents available for download there. Purchasing USB ALDL Interfaces are $100 plus $20 postage and handling. Combined shipping is available when purchased with a PCMHACKING.net ECM or PCM NVRAM.

If purchasing with an ECM NVRAM Antus can supply.

About WinALDL is software to datalog on GM vehicles that use the old 160 baud rate. This includes but is not limited to vehicles using a 1227747 and 1227165 ECM.

Most older TBI GM computers will speak this protocol. WinALDL does NOT speak to newer GM OBD1 vehicles that use 8192 baud communication. WinALDL is available from WinALDL was written several years ago. Software input data penduduk.

It will work best on Windows XP or older operating systems, if available. You may need to use a VM or Windows XP compatibility mode on newer Windows7 systems in order for it to run 100% properly.

WinALDL will work with both our ALDU1 and AutoProm. Setup There are a few setup tasks that need to be performed. • Ensure that your ALDU1 or AutoProm is assigned a COM port between 1 and 4. Make sure you choose a port that does not conflict with system resources. (see ) • If you are using the AutoProm, ensure that it is set to pass-through *NOT* AutoProm mode. (see ) • On most 160 baud applications, you will need to set the switch to 10k mode on your AutoProm or ALDU1 • Set the COM port selection in WinALDL to match what it set up to on the USB driver under the control panel. • Set the baud rate to 4800 within the WinALDL program.

• Select the ECM type in WinALDL which matches your ECM. • Make sure the ALDU1 is connected to the laptop prior to starting the software. • Turn your key off, connect the ALDU1 to the car, and start the software. • Turn the car on, it should connect.